Auto Reset; Hold Time - norbar NorTronic ASCII Operator's Manual

Auto Reset (AR)
• With Auto Reset on, the tool automatically resets after the Hold Time has expired on completion of a
successful tightening.
Command
SC:AR:0
SC:AR:1
Response
OK:0
OK:1
Example
Hold Time (HT)
The length of time (in seconds) the display will be held after the completion of a successful tightening
•
and before resetting. Only applicable if Auto Reset is On.
Set Hold Time (1 – 10) secs
•
Command
SC:HT:?
Response
OK:1 – OK:10
Example
(Set Auto Reset OFF)
(Set Auto Reset ON)
(Auto Reset OFF)
(Auto Reset ON)
Set Hold Time- (default 4, range 1 – 10)
Default
29