Collector Removal - Briggs & Stratton 1695284 Operator's Manual

WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower discharge
deflector MUST be properly installed in the down
position and retained by the spring latch.
Removal
1. Unhook rubber strap (P, Figure 11) from pin (Q), then
remove tube assembly (O) from chute (R) and from
cover (I).
2. Lift cover (I) and remove bags (J) from bag and cover
support assembly (B).
Note: Support the cover during the next step.
3. Remove cover (I) by disconnecting retainer springs
(G), then remove both hinge pins (F).
4. Remove bag and cover support assembly (B) from
hitch assembly (A) by removing retainer spring (E),
then removing mount pin (D).
Note: To prevent loss of pins and retainer springs
re-attach them to the cover, and bag and
cover support assembly.
5. Remove wing nut (U) from carriage bolt (W).
6. Remove knob (S) from carriage bolt (T).
7. Lift up discharge deflector (V)and remove chute (R)
from carriage bolt (T and W).
IMPORTANT: See that discharge deflector (R) returns to
the DOWN position.
11
Normal Removal