Operator Safety Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment. The triangle in text signifi...
Assembly Install Mounting Spacers - Conquest / 1700 / Before beginning any service work turn WARNING: 2700 / yt & Prestige / 1800 / 2800 / GT Series off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s). Install Spacers 1.
Assembly Remove Blowout Baffl e Install Baffl es 1. Remove and discard short blowout baffl e (A, Figure 4), 1. Determine which baffl e to use. See Chart in Figure 5. carriage bolts (B) and locknuts (C) from mower deck (D). 2.
Assembly Install Mounting Plate Install Hitch and Upright Support Assembly 1. Install mounting plate (A, Figure 6) to mower deck as 1. Attach hitch and upright support assembly (A, Figure 8) shown. Secure with 5/16-18 x 5/8 carriage bolts (B) and to frame spacers (B) as shown.
Assembly Install Collector Bags Installing Upper & Middle Tubes 1. Raise the cover (A, Figure 10). 1. Slide middle tube (A, Figure 12) into upper tube (B). 2. Attach collector bags (B) using grass bag hanger (C) to 2. See Figure 12 for correct hole location and secure the bag hanger post (D).
Operation Before Operation Clear the lawn of all sticks, stones, wire and other debris which may be caught or thrown by the mower blades. Check grass condition. If wet, wait until later in the day. If grass is wet, the grass catcher is likely to become plugged.
Operation 4. Lift discharge defl ector (F). Remove lower chute rod (G) from mounting plate (H). 5. Remove mounting strap (I) from locknut and capscrew (J) and pull lower chute away from mower. 6. Remove all carriage bolts (K) and nuts (L) and remove baffl...
Warranty BRIGGS & STRATTON POWER PRODUCTS GROUP, L.L.C. OWNER WARRANTY POLICY LIMITED WARRANTY Briggs & Stratton Power Products Group, LLC will repair and/or replace, free of charge, any part(s) of the equipment that is defective in material or workmanship or both. Briggs & Stratton Corporation will repair and/or replace, free of charge, any part(s) of the Briggs and Stratton engine* (if equipped) that is defective in material or workmanship or both.