Related Manuals for Briggs & Stratton 1697363A-00
Summary of Contents for Briggs & Stratton 1697363A-00
- Page 1 80099036 © Briggs & Stratton, LLC Milwaukee, WI, USA. All Rights Reserved. Revision A...
-
Page 2: Table Of Contents
Table of Contents: General Information.............. 3 Operator Safety..............3 Safety Alert Symbol and Signal Words......3 Hazard Symbols and Meanings........3 Safety Warnings - Grass Catchers........3 Safety Decals - Triple Catcher........4 Hardware and Parts - Grass Catcher........4 Installation................5 Install the Side Plates............ -
Page 3: General Information
General Information Symbol Meaning Keep hands and feet away from deck. For additional information, refer to the Customer Contact Guide included with the unit. The illustrations in this document are representative. Your unit might look different from the images shown. LEFT and RIGHT are referenced from the operator's Thrown object hazard position. ... -
Page 4: Safety Decals - Triple Catcher
Callout Hazard Part Number WARNING Thrown Objects Hazard 7104709 Thrown Objects Hazard Do not open the cover while the blades are turning. Hardware and Parts - Grass • Check the catcher system to make sure it is bolted tightly to the unit. Catcher •... -
Page 5: Installation
• Put the mower into the lowest position. It is important to complete the removal and installation of the hardware on the left side of the draw bar before the removal and installation of the hardware on the right side. Install the Side Plates Broadmoor™... - Page 6 2. Remove and discard the existing hardware (b, Figure 7) from the UPPER mounting hole on the left side of the frame. Repeat for the other side. Broadmoor with Suspension 1600/2600 LT Series, CTX 9000 Models with Suspension Use the Hardware Parts Bag: BB 1.
-
Page 7: Install The Upright Support Assembly
Install the Upright Support Assembly Note: If the rear frame support hardware INCLUDES the spacers, proceed to Step 2. Broadmoor without Suspension 1600/2600, LT Series, CTX 9000 Models 1. Put the upright support assembly (O, Figure 13) on the spacers (F). 1. Remove and discard the existing hardware (a, Figure 10) from the UPPER mounting hole on the left side of the rear frame support. -
Page 8: Install The Cross Support, Catcher Bags And Cover Assembly
Attach the Cover Assembly Use Hardware Parts Bag: CC 1. Put the corner brackets (a, Figure 18) on the cover assembly (M) onto the pivot hinges (b). Install the hinge Install the Cross Support, Catcher Bags pins (J) and hair pins (K). and Cover Assembly Install the Cross Support Use Hardware Parts Bag: CC... -
Page 9: Operation
Operation 1. Lift up the cover assembly (M, Figure 19). Remove and General Instructions for Grass Catchers the catcher bags (N). 2. Remove the catcher tube assembly (a) from the cover WARNING assembly. Disengage the electric clutch (PTO). Shut off the engine, 3. -
Page 10: Briggs & Stratton Products Warranty Policy
If paint has been scratched on metal parts, touch up with Improper Maintenance or Repair - This product must be maintained according to the procedures and schedules paint, or apply a thin film of oil to prevent corrosion. provided in the Operator’s Manual, and serviced or repaired Store in a dry area. - Page 11 2. Align each template with the side of the rear frame support (a, Figure 23) and attach with tape. 3. Put a mark in the center of the holes. 4. Drill the holes on each side with a 17/32” drill bit.