Related Manuals for Briggs & Stratton 1697358A-00
Summary of Contents for Briggs & Stratton 1697358A-00
- Page 1 ATTACHMENT OPERATOR’S MANUAL 1697358A-00 Twin Bag Grass Catcher © Briggs & Stratton, LLC 80098883 Milwaukee, WI, USA. All rights reserved. Revision A...
-
Page 2: Table Of Contents
Manual Contents: Keep hands and feet away from deck. Operator Safety..............2 Hardware and Parts Identification........4 Assembly .................5 Thrown object hazard. Operation.................6 Removal................7 Storage................7 Roll over hazard. Warranty................8 General Information The illustrations in this document are representative. Your unit may vary from the images displayed. LEFT and RIGHT WARNING are referenced from the operator’s position. - Page 3 Decal Icon Definitions WARNING Thrown Objects Hazard WARNING: Thrown objects hazard. Do not open the cover while the blades are turning. Objects thrown by the mower can seriously injure or kill you. • Check the collection system to make sure it is bolted tightly to the unit.
-
Page 4: Hardware And Parts Identification
Hardware and Parts Identification - NUT, Speed - SHOULDER BOLT - REAR SUPPORT FRAME .3125”-18 (Qty. 2) .3125”-18 x 1.62” LG (Qty. 2) (Qty. 1) - BOLT, Carriage - NUT, Whiz Lock .375”-16 x 1.0” (Qty. 4) .375”-16 (Qty. 4) - BAG and COVER SUPPORT (Qty. -
Page 5: Assembly
Assembly Install the Bag and Cover Support 1. Position the holes in the bag and cover support (H, The uppercase letters refer to the hardware and the parts in Figure 3) with the holes of the rear support frame. Install the kit. -
Page 6: Operation
Operation Install the Catcher Bags 1. Lift the cover. WARNING 2. Put the bag hangers (c, Figure 5) on the catcher bags (J) onto the hanger posts (d). Disengage the electric clutch (PTO). Shut off the engine, Note: Fold the seat forward to let the cover stay in the up remove the key, and wait for all moving parts to stop position. -
Page 7: Removal
Removal Storage WARNING Clean the grass catcher with a mild detergent. Remove debris from the screen on the bottom of the lid. When operating without the catcher, the mower deflector MUST be installed in the down position. If paint is scratched on metal parts, paint the parts again, or apply a thin layer of oil to prevent corrosion. -
Page 8: Warranty
Warranty BRIGGS & STRATTON PRODUCTS WARRANTY POLICY ® LIMITED WARRANTY Briggs & Stratton warrants that, during the warranty period specified below, it will repair or replace, free of charge, any part that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below.