Section 3: Installation; Machine Package Receipt/Inspection; Machine Package Prep - Vanair ALL-IN-ONE POWER SYSTEM AIR N ARC 150 Series Operations Manual & Parts List

Welder, generator, air compressor, battery booster

Table of Contents

AIR N ARC

150 SERIES

3.1 MACHINE PACKAGE

RECEIPT/INSPECTION

Upon receipt of the machine package,

inspect the exterior of the shipping crate for

signs

shipping/transit

damage should be reported immediately to

the shipping company. Open the lid and

inspect the component parts and supports to

ensure that there has been no internal

movements of assemblies or components

which may have caused damage. Contact

Vanair Manufacturing, Inc. to report missing

items, incorrect part number, or other

discrepancies:

Vanair Manufacturing, Inc.

10896 West 300 North

Michigan City, IN 46360

Phone: (219) 879-5100

Service: (844)VANSERV

Service Fax: (219) 879-5335

Parts Fax: (219) 879-5340

Sales Fax: (219) 879-5800

3.2 MACHINE PACKAGE

PREP

Grounding must consist of a minimum 10

gauge wire between the instrument panel,

the machine, and the truck chassis.

DO NOT install in enclosed spaces.

VANAIR MANUFACTURING, INC.

(800) 526-8817 • www.vanair.com

SECTION 3:

INSTALLATION

damage.

(800) 526-8817

[844-826-7378]

DANGER

090043-OP_r0 (MARCH -2015)

ELECTRICAL HAZARD! Be sure the

battery is disconnected before starting

Any

Install electrical components (circuit

breakers, pressure switches, toggle

switches, etc.) in locations where

exposure to water or moisture will be

In order to prevent accidental damage to

vehicle components (fuel tanks, lines,

brake lines, wiring harnesses), note their

location before drilling any holes.

Installation must adhere to the safety

precautions listed in the Safety Section of

this manual for cooling and noxious fume

If mounting footprint is tighter than the

recommended minimum requirements,

consult the Vanair Service Department for

For guidance on machine start-up

procedure and control panel functions,