Compressed Air Can Cause Injury; Trapped Air Pressure And Whipping Hoses Can Cause Injury; Hot Metal From Air Arc Cutting And Gouging Can Cause Fire Or Explosion; Hot Parts Can Cause Severe Burns - Vanair ALL-IN-ONE POWER SYSTEM AIR N ARC 150 Series Operations Manual & Parts List

®
AIR N ARC 150 SERIES
1.6.3 COMPRESSED AIR CAN CAUSE
INJURY
1.6.4 TRAPPED AIR PRESSURE AND
WHIPPING HOSES CAN CAUSE
INJURY
1.6.5 HOT METAL FROM AIR ARC
CUTTING AND GOUGING CAN
CAUSE FIRE OR EXPLOSION
1.6.6 HOT PARTS CAN CAUSE
SEVERE BURNS
1.6.7

READ INSTRUCTIONS

Read Owner's Manual before
using or servicing unit.
Stop engine and release air
pressure before servicing.
VANAIR MANUFACTURING, INC.
(800) 526-8817 • www.vanair.com
Wear approved safety
goggles.
Do not direct air stream
toward self or others.
Release air pressure from
tools and system before
servicing, adding
changing attachments, or
opening compressor
drain or oil fill cap.
Do not cut or gouge near
flammables.
Watch for fire; keep
extinguisher nearby.
Do not touch hot parts bare
handed.
Allow cooling period before
working on equipment.
090043-OP_r0 (MARCH-2015)
Use only genuine Air N Arc replacement
parts.
It is mandatory that all operators read this
manual before operating or servicing the
Air N Arc 150 Series All-In-One Power
System. Failure to do so could result in
death, bodily
equipment.
1.7 ADDITIONAL SYMBOLS FOR
INSTALLATION, OPERATION
AND MAINTENANCE
1.7.1 FALLING UNIT CAN CAUSE
INJURY
or
oil
correct procedures.
If using lift forks to move unit, be sure forks
are long enough to extend beyond opposite
side of unit.
1.7.2 OVERHEATING CAN DAMAGE
MOTORS
engine speed damage electric motors.
1.7.3 FLYING SPARKS CAN CAUSE
INJURY
wearing proper face, hand, and body
protection.
SECTION 1: SAFETY
injury, or damage
Use lifting bail to lift unit and
properly installed
accessories only.
Lift and support unit only
with proper equipment and
Turn off or unplug
equipment before starting or
stopping engine.
Do not let low voltage and
frequency caused by low
Wear a face shield
protect eyes and face.
Shape tungsten electrode
only on grinder with proper
guards in a safe location
PAGE - 7
to
to