Vanair ALL-IN-ONE POWER SYSTEM AIR N ARC 150 Series Operations Manual & Parts List page 50

SECTION 5: MAINTENANCE
A
B
C
KEY DESCRIPTION
A TAB
B LINK END
C THUMB (pushing on tab)
2
1
KEY
Start at bottom edge of compressor pulley: Set belt into
1
groove, and grasp both the belt and the pulley edge
2 Rotate the pulley clockwise, while still holding the belt in
place.
tabs are facing inward toward the
pulley, and the arrows on the belt
point in the same direction as the
arrow of rotation on the
compressor pulley (see Figure 5-
4 [D]).
PAGE - 40
D
E
C
Figure 5-6: Attaching Compressor Belt Link
3
DESCRIPTION
Figure 5-7: Compressor Drive V-Belt - Removal/Attachment
090043-OP_r0 (MARCH - 2015)
A
D
F
90°
2
KEY
D THUMB (pushing on link end)
E TOP VIEW: tab pivoting into link slot
F TOP VIEW: twist tab to lock the link in place
KEY
3 Hold the belt firm enough so that it does not
E slip from the engine pulley. Move the belt to
align with the compressor pulley groove as it
is being rotated.
3. Start at the bottom edge of the
pulley as per Figure 5-7, Step
#1. Continue to set the belt into
the proper groove on the
compressor pulley and engine
pulley.
®
AIR N ARC 150 SERIES
1
B
3
DESCRIPTION
DESCRIPTION
VANAIR MANUFACTURING, INC.
(800) 526-8817 • www.vanair.com