Section 3: Installation; Air N Arc I-300 Series All-In-One Machine Package Receipt/Inspection; General Overview Of Installation - Vanair AIR N ARC I 300 SERIES Operation Manual

®
AIR N ARC I-300 SERIES ALL-IN-ONE POWER SYSTEM
3.1 AIR N ARC I-300 SERIES ALL-
IN-ONE POWER SYSTEM
MACHINE PACKAGE
RECEIPT/INSPECTION
Upon receipt of the machine package,
inspect the exterior of the shipping crate for
signs of shipping/transit
damage should be reported immediately to
the shipping company.
Before fully unpacking the unit, inspect
the component parts, supports and loose-
packed parts to ensure that there have
been no internal movements of
assemblies or components, which may
have been damaged during shipment.
Should any damage be discovered during
package inspection, contact the shipping
company immediately.
Contact Vanair
(219) 879-5100 / (800) 526-8817
Service Fax: (219) 879-5335
www.vanair.com
to report missing items, incorrect part
numbers, or other discrepancies.
3.2 GENERAL OVERVIEW OF
INSTALLATION
DISCLAIMER
DO NOT install in any enclosed space
without first contacting Vanair.
SECTION 3:
INSTALLATION
damage. Any
NOTE
NOTE
®
at
090045-OP_r1
®
The lifting bail on the I-300 package is
rated to the machine weight only. DO
NOT overtax the lifting bail.
Grounding must consist of a minimum
two (2) gauge wire between the
instrument panel, the machine, and the
ELECTRICAL HAZARD! Be sure the
battery is disconnected before starting
Although much of the information given
in this installation section is
comprehensive, these guidelines should
be considered as referential material only,
due to the diverse possibilities of the end
user's vehicle make, model and year, and
the unit model specifications.
Install electrical components (circuit
breakers, pressure switches, toggle
switches, etc.) in locations where
exposure to water or moisture will be
most minimized.

SECTION 3: INSTALLATION

WARNING
WARNING
truck chassis.
WARNING
the installation.
NOTE
NOTE
PAGE - 17