®
AIR N ARC
150 SERIES
KEY
DESCRIPTION
A
ENGINE
E
I
FUSE, 30A
I
Replacement fuses can usually be found at local
vendor carriers such as automobile supply
stores, hardware stores, etc.
Figure 5-9: Fuse Location
1. Remove the bolt [A] and washer
[B] from the rear-side of the
engine ignition housing [C].
2. Locate the fuse housing and
open the cap to expose the fuse.
3. Remove the blown fuse [E], and
replace with new fuse.
4. Replace the fuse housing cap to
secure the fuse.
VANAIR MANUFACTURING, INC.
(800) 526-8817 • www.vanair.com
5.6 STORAGE AND
5.6.1 INTERMITTENT USE
5.6.2 LONG TERM STORAGE
090043-OP_r0
(MARCH - 2015)
SECTION 5: MAINTENANCE
5. Replace the rear-side ignition
housing onto the front-side
ignition housing [C].
6. Secure into place with the washer
and bolt.
INTERMITTENT USE
If the unit is not used very regularly always
treat the fuel with a fuel stabilizer.
Check all belts and hoses for signs of
deterioration such as visible surface cracks,
stiffness or discoloration.
Disconnect
the
battery
connected to the positive (+) side of the
battery.
Depressurize the air tank and open the drain
valve on the tank.
Cover the unit with a tarp or plastic to
prevent the accumulation of dust, but leave
the bottom open for air circulation.
Fill gas tank with fuel and fuel stabilizer to
prevent moisture build-up in the tank.
cable
that
is
PAGE - 43