Power Requirement
Power Supply and fuse
Power Supply and fuse
Before turning on the E5092A, be sure to verify the following:
Power Requirements
The E5092A requires the following power source:
Voltage
Frequency
Maximum power consumption
Use the fuse that meets the following specifications.
UL/CSA type, Slo-Blo, 5×20 mm miniature fuse, 3A 250V (Agilent part number:
2110-1017)
Spare fuses are available from Agilent Technologies sales office. To check or replace the
fuse, disconnect the power cable and pull out the fuse holder.
Figure A-1
Fuse holder and power cable inlet
Power Cable
In accordance with international safety standards, this instrument is equipped with a
three-wire power cable. When connected to an appropriate ac power outlet, this cable
grounds the instrument frame. The type of power cable shipped with each instrument
depends on country of destination.
200
*1. The E5092A automatically switches between them depending on the voltage.
Setting up fuse
Requirements
90 to 132 VAC or 198 to 264 VAC
47 to 63 Hz
70 VA
*1
Appendix A