3.2.4
Waveform output method setting
Set the waveform output method using "Switch 4" of "Switch setting for I/O and intelligent function module".
Correspondence between the value from 0 to 1 set for "Switch 4" and the waveform output method
When Module READY (Xn0) turns on, the transmission waveform is output.
When Module READY (Xn0) and Transmission waveform output command (Yn2) turn on, the
transmission waveform is output.
*1
The value other than 0 and 1 is reserved by the system. Do not change the settings.
40
Waveform output method
Enter 0 and 1 in this
column.
"Switch 4"
0
1
*1