Completing The Installation - AMX CP-20A Instruction Manual

Amx cp-20a control panels: user guide

Hide thumbs Also See for CP-20A:

Table of Contents

Installing a CP-20A Remote

We recommend completing the installation by performing a test switch to make sure the system is

working properly (see below).

Note: If the panel is experiencing difficulties, insert a 120 ohm resistor in the outer contacts of the

unused Comm Link on the last remote of a large daisy chain and tighten the screws. If problems

persist, contact technical support (for contact information, see page 39).

Completing the Installation

We recommend completing the installation by executing a test switch routing Input 1 to Output 2 on the

level designated by the enclosure's "Connector Guide."

To execute a test switch:

At the Main Menu screen, choose the Change command.

If the Change command is not available, press the Function key to view additional

Main Menu options.

The Change Input screen appears, displaying the available input options.

Locate Input 1 by scrolling through the list using the arrow keys.

(Press and hold an arrow key to scroll quickly.)

CP-20A Instruction Manual

Table of Contents