Table of Contents
Advertisement
Installing a CP-20A Remote
To connect the CP-20A Remote to an AMX AutoPatch Router:
1.
On the CP-20A Remote, unplug one of the Comm Link connectors.
2.
Loosen the two outer screws on the connector.
3.
Insert the two wires of the XNNet link cable into the two outer slots of the connector, leaving the
center slot empty (FIG. 5).
Note that either wire can be inserted into either of the outer slots.
FIG. 5
Insert the wires into a Comm Link
4.
Tighten both screws and plug the connector back into the Comm Link.
5.
On the router's CPU, unplug the XNNet connector (for XNNet connector location, see the router
documentation).
6.
Loosen the two outer screws on the connector.
7.
Insert the two wires from the CP-20A Remote into the two outer slots of the connector from the
CPU, leaving the center slot empty (FIG. 6).
Note that either wire can be inserted into either of the outer slots.
8.
Tighten the screws and plug the connector back into the CPU.
FIG. 6
Insert the wires into the XNNet connector on the CPU (Optima shown)
32
XNNet link cable to router
CPU location may vary depending on router
XNNet link cable from the remote
CP-20A Instruction Manual
Advertisement
Table of Contents
