Hard Drive - HP OMEN X 17 Maintenance And Service Manual

Hard drive

Description
Hard drive (hard drive cable is spared as 940595-001 and the hard drive bracket is spared as 940599-001)
1 TB 7200 RPM SATA RAW 9.5 mm
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
Remove the hard drive:
NOTE: Use minimal force when lifting the locking bar up on the ZIF connector and disconnecting the cable.
1. Open the zero insertion force (ZIF) connector to release the hard drive cable (1) from the system board.
2. Remove the hard drive connector cable from the ZIF connector (2).
3. Lift up on the tab connected to the system board cable (3). Pull the tab (4) to disconnect the hard drive
cable from the system board.
4. Lift the top edge of the hard drive upward (5).
Base enclosure on page
Battery on page 31)
38)
Component replacement procedures
Spare part number
766644-001
33