Display Assembly - HP OMEN X 17 Maintenance And Service Manual

Display assembly

Description
Antenna, dual
Back cover
Camera
Display bezel
Display cable
● For products with non-touch FHD screen with HD camera, 120 Hz
● For products with non-touch UHD screen with HD camera, 120 Hz
Hinge
Hinge support bracket
Raw panel 43.94 cm (17.3") (non-touch screen)
● FHD WLED AntiGlare (1920 x 1080) flat-flat (4.0 mm) UWVA, eDP1.3 + NVSR, Support NVIDIA G-Sync
120Hz
● UHD WLED AntiGlare (3840 x 2160) flat-flat (4.0 mm) UWVA, eDP + PSR, Support NVIDIA G-Sync
FHD LED AntiGlare (1920 x 1080) flat-flat (4.0 mm) UWVA, eDP + PSR, Support NVIDIA G-Sync
●
IMPORTANT:
and replacement.
Before removing the display assembly, follow these steps:
1. Shut down the computer.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices connected to the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
c. Speakers (see
d. Remove the fans (see
e. Remove the heat sink (see
f. Remove the system board (see
Remove the display assembly:
1. Remove the 12 Phillips screws from the hinge.
54 Chapter 6 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Base enclosure on page
Battery on page
Speakers on page
Fan on page
Heat sink with fan on page
38)
31)
45).
41)
42)
System board on page 47)
Spare part number
940583-001
940584-001
940626-001
940586-001
940593-001
940594-001
940603-001
940604-001
940614-001
940615-001
L12056-001