Ssd (M.2) - HP OMEN X 17 Maintenance And Service Manual

SSD (M.2)

Description
M.2 SATA SSD, PCIe NVMe TLC
● 128 GB 2280 M2 3 x 4 SS Value PA
● 1 TB 2280 M2 PCIe 3 x 4 SS NVMe TLC PA
● 256 GB 2280 M2 PCIe 3 x 4 SS NVMe TLC PA
● 512 GB 2280 M2 PCIe 3 x 4 SS NVMe TLC PA
Before removing the SSD, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
Remove the SSD:
1. Remove the Phillips screw (1) that secures the SSD to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the SSD.
Base enclosure on page
Battery on page 31)
38)
Component replacement procedures
Spare part number
940617-001
940618-001
940619-001
940620-001
37