Replacing Wind Vane And Cable; Replacing The Wind Vane Arm; Protective Cap - Raymarine i60 Installation Instructions Manual

5. Unscrew the cable retention nut and remove from the base.
6. Unscrew the base fixing screws.
7. Remove the base leaving the cable in place.
8. Remove the cable washer from the end of the cable connector.
9. Replace the cable washer with the new one supplied.
10. Fit the new base to the cable, ensuring the located tag at the top of the cable connector is
engaged in the groove in the new base.
11. Re-assemble following the above instructions in reverse order from step 6 to step 1.

Replacing wind vane and cable

When replacing an existing wind vane you can either fit the new wind vane including the new cable,
or you can keep the existing installed cable. It is recommended that the wind vane base is changed.
The method below describes replacing the wind vane, base and cable.
1. Release the arm from the retaining clip.
2. Push the plastic sleeve up the arm and unscrew the locking collar
3. Pull the wind vane arm away from its base.
4. Unscrew the base fixing screws.
5. Remove the base and cable.
6. Install the new wind vane and cable, utilizing the existing base fixing holes and following the
steps above in reverse order.

Replacing the wind vane arm

1. Release the arm from the retaining clip.
2. Push the plastic sleeve up the arm and unscrew the locking collar.
3. Pull the wind vane arm away from its base.
4. Using the new wind vane reassemble following the above steps in reverse order.

Protective cap

The protective cap provides protection against water and dust ingress to the cable connector when
servicing, maintaining or replacing your wind vane.
If the arm is being removed for servicing, maintenance or replacement, use the protective cap.
Installation 23