Raymarine i60 Installation Instructions Manual page 19

Note:
Do NOT remove the protective cap from the base connector until you are ready to fit the wind
vane arm.
1. Decide on the cable routing option that suits your installation.
2. Mark the mounting surface based on your cable routing option:
i. Option 1 — Place the base of the unit in the desired location, with the connection end facing
directly forwards, and mark the position of the mounting holes.
ii. Option 2 — Use the supplied mounting template to mark the position of the mounting holes
and the cable hole.
3. Drill holes in the mounting surface based on your chosen cable routing option:
i. Option 1 — Drill a hole at each of the 2 mounting hole locations.
ii. Option 2 — Drill a hole at each of the 2 mounting hole locations and an 8 mm hole for the
cable routing.
4. Unreel the unit's cable from the spindle it is supplied on.
5. If option 2 has been chosen or you need to use the junction box, you may need to remove the
spade terminals from the end of the cable to feed the cable through the hole in the mounting
surface.
6. Using the provided fixings secure the unit's base to the mounting surface, ensuring that the cable
does not get squashed between the base and the mounting surface.
7. Remove the protective cap from the connector in the base, ensuring it stays attached to the base.
8. Ensuring correct connector orientation, insert the wind vane assembly into the base.
9. Slide the locking collar down the arm towards the base.
10. Tighten the locking collar using one hand and turning clockwise until tight.
11. Slide the rubber cover down the arm and fit to the end of the locking collar.
Installation 19