Mounting The Junction Box - Raymarine i60 Installation Instructions Manual

12. Use the retaining clip to secure the arm of the wind vane.
13. Route the cable back to the display, using the junction box if required.
14. If you had to remove the spade terminals then new spade terminals (not supplied) must be
fitted to each wire.
15. Connect the spade terminals to the relevant connectors on the back of the display.

Mounting the junction box

The junction box can be mounted using the supplied screws or double sided adhesive pads.
The junction box should be mounted below decks, close to the cable entry point.
1. To mount the junction box using the fixings screws (supplied) follow the steps below:
i. Hold the junction box against the mounting surface at the desired location.
ii. Mark the location of the mounting holes on the mounting surface.
iii. Drill 2 holes in the mounting surface at the marked locations.
iv. Holding the junction box in place, secure to the mounting surface using the supplied screws.
2. To mount the junction box using the double sided pads (supplied) follow the steps below:
i. Remove the backing from one side of the double sided adhesive pads
ii. Evenly space the adhesive pads and stick to the rear of the junction box.
iii. Remove the backing from the opposite side of the adhesive pads.
iv. Hold the junction box against the mounting surface at the desired location.
v. Apply firm pressure to the front of the junction box to ensure the pads adhere the junction box
to the mounting surface.
3. Feed the necessary cables through the grommets in the junction box.
4. Connect the relevant wires together inside the junction box using the supplied terminal block.
5. Place the lid onto the junction box.
6. Use the screws provided to secure the lid to the junction box.
20