Disassembly Of Base - Invacare NordBed Ultra Service Manual

Invacare® NordBed™
12.
One after another, tip the two halves gently onto the
floor and to an upright position onto the bed end
brackets.
13.
Place the actuator cables in the clips and fold out the
back section / leg section until the mattress support
halves are in balance and let them stand aside.
14.
Place the actuator cable in the clip and wind the
power and hand control cable around the ends of
tube D and attach the hand control to tube E.
12

5.2 Disassembly of base

NordBed Optimo and NordBed Optimo Wide 105 cm only
1.
Lock the short lifting mechanism by pulling up the
lever with the red locking cam and pushing the locking
cam firmly over the tube A.
2.
Grab the square tube B with one hand and the
tube C with the other hand. Release the lock on
the subframe by pulling the blue marked string D
towards the blue marked tube C with one hand.
When the lock has been released hold the short lifting
mechanism in a horizontal position and lower the long
lifting mechanism onto the floor.
1657009-A