Table of Contents
Advertisement
3.2.3 Bed end brackets
Depending on the bed end to be mounted, it might be
required to pre-mount or change the bed end brackets.
Mounting
1. Insert the bed end brackets into the side tubes of the
mattress support platform.
2. Fix the bed end brackets on the side tubes with the
screws from below and tighten firmly.
Dismounting
1. Remove the screws and pull the bed end brackets out
of the side tubes.
3.3 Mattress support extension
For patients, taller than 185 - 190 cm it is recommended
to extend the mattress support of the bed.
WARNING!
Risk of injury
The user can get trapped or suffocated.
– Always extend the mattress when extending
bed.
– There must be a distance of more than 2,5
cm, between the bed end and the mattress
bow, to avoid entrapment of fingers.
– Always make sure to tighten the screws for
the mattress support extension.
The bed can be extended 5 or 10 cm in both ends of the
bed – to a maximum extension of 20 cm.
1657009-A
1. If applicable, dismount the side rails, bed ends and
lifting pole.
2. To extend the bed in the foot end:
a. Loosen the screws A underneath the side tubes.
b. Pull out the bed end brackets B by 5 or 10 cm,
and re-tighten both screws A.
c. Loosen the screws C on the mattress bow D and
pull it out to match the extension.
d. Make sure there is at least 2,5 cm between the
mattress bow D and the bed end and re-tighten
both screws C
3. To extend the bed in the head end:
a. Loosen the screws A underneath the side tubes.
b. Pull out the cross tube B by 5 or 10 cm, and
re-tighten both screws A.
c. Loosen the screws C on the mattress bow D and
pull it out to match the extension.
d. Make sure there is at least 2,5 cm between
the mattress bow D and the cross tube B and
re-tighten both screws C
4. Replace the mattress or put in a fitting mattress piece.
5. If applicable, mount the side rails, bed ends and lifting
pole.
Loose mattress pieces should always be fitted in
the head end of the bed.
Setup
7
Advertisement
Table of Contents
