Table of Contents
Advertisement
Invacare® NordBed™
3 Setup
3.1 General safety information
WARNING!
Risk of injury or damage
Damaged parts may affect the safety of the
product.
– Check all parts for shipping damage before
use.
– In case of damage, do not use the product
and contact your Invacare provider for further
instructions.
3.2 Installing bed ends
3.2.1 Bed ends for Sanne-bracket
CAUTION!
Risk of squeezing
If the bed end is not correctly locked it can fall
down and cause injury to user.
– Make sure the locking pins are engaged.
Mounting
1.
Pull out the locking pin and rotate by 90 degrees to
disengage from the bed end on both sides.
2.
Align the slots in the bed end with the tabs on the
Sanne bracket and place the bed end onto the tabs.
6
3. Push down firmly and ensure that the bed end is fully
seated in the tabs.
4.
Rotate the locking pin and allow it to engage with the
bed end on both sides.
Dismounting
1. Pull out the locking pin and rotate by 90 degrees to
disengage from the bed end on both sides.
2. Hold the bed end firmly on each side and pull up
vertically on both sides at the same time.
3.2.2 Bed ends for Quick-bracket
Mounting
1.
Align the slots on the bed end with the tabs on
the Quick bracket and lower the bed end onto the
brackets.
2.
Press down firmly and ensure the bed end is fully
seated on the brackets.
Dismounting
1. Hold the bed end firmly on each side and pull up
vertically on both sides at the same time.
1657009-A
Advertisement
Table of Contents
