Adjust The Cutting Height - Gardena SILENO city Operator's Manual

3. The display shows a message that charging is in
progress.

4.7 Adjust the cutting height

CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
4.7.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch.
3. Turn the knob to the required position.
• Turn clockwise to increase the cutting height.
• Turn counter-clockwise to decrease the
cutting height.
4. Close the hatch.
32 - Operation 1298 - 007 - 16.09.2020