Operating Mode Park; To Stop The Product; To Switch Off The Product; To Charge The Battery - Gardena SILENO+ Operator's Manual

4.3.4 Spot cutting
Spot cutting function is activated with the START
The
button and is useful for quickly mowing an area where
the grass has been mown less than in other parts of the
yard. You must manually move the product to the
chosen area.
Spot cutting means that the product mows in a spiral
pattern in order to cut the grass in the area where it was
started. When this is done, the product automatically
switches back to Main area or Secondary area .

4.4 Operating mode Park

Push the PARK button to select the following operating
modes:
Park until further notice
•
Start with schedule
•
4.4.1 Park until further notice
The operation mode Park means that the product goes
back to the charging station where it stays until a new
operation mode is selected and the START button is
pushed.
4.4.2 Start again with next schedule
The product stays in the charging station until the next
Schedule setting permits operation. This operating mode
is suitable if you want to cancel an ongoing mowing
cycle and allow the product to stay in the charging
station until the next day.

4.5 To stop the product

1. Push the STOP button on top of the product.
The product stops and the blade motor stops.

4.6 To switch off the product

1. Push the STOP button on top of the product.
2. Set the Main switch to position
30 - Operation

4.7 To charge the battery

When the product is new or has been stored for a long
period, the battery can be empty and needs to be
charged before starting. In the
product automatically alternates between mowing and
charging.
1.
2.
3.

4.8 Adjust the cutting height

The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (6 cm / 2.4 in.).
4.8.1 To adjust the cutting height
1.
2.
0 .
3.
4.
WARNING:
Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
Main area mode, the
Set the Main switch to position
Place the product in the charging station. Slide the
product in as far as possible to ensure proper
contact between the product and the charging
station. Refer to contact and charging plates in
Product overview on page 4
The display shows a message that charging is in
progress.
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
Push the STOP button to stop the product.
Open the hatch.
Turn the knob to the required position.
• Turn clockwise to increase the cutting height.
• Turn counter-clockwise to decrease the
cutting height.
Close the hatch.
1378 - 005 - 17.09.2020
1 .