Gardena SILENO city Operator's Manual page 27

2. Use the arrow buttons and the OK button to move
through the menu structure
Coverage > Area 1-3 > More > Reset .
3. Push the OK button.
3.10.7 Starting point
This function allows you to control how far the product
drives along the guide wire from the charging station
before it starts operating. The factory setting is 60 cm / 2
ft. and the maximum distance is 300 cm / 10 ft.
Note:
The product straddles the guide wire from the
charging station to the starting point. Keep as short
distance to the starting point as possible to reduce the
risk of tracks forming on the lawn.
If the charging station is placed in a limited space area,
for example under a veranda, choosing a good starting
point is important so that the guide calibration process is
Guide calibration on page 22 .
optimized. Refer to
A
B
A) Starting point
B) Minimum distance 60 cm / 2 ft (perpendicular to the
guide wire). If less distance, the calibration process is
interrupted. For the widest possible guide corridor, have
a minimum distance of 1.35 m / 4.5 ft. Refer to
calibration on page 22 .
3.10.7.1 To set the starting point
To get access to the menu on
1. Do steps 1-3 in
page 23 .
2. Use the arrow button and the OK button to move
through the menu structure
> Starting point .
3. Use the arrow buttons to specify the distance in
cm.
4. Push the BACK button.
3.10.8 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting is 32
cm / 12 in. You can select a distance of 20-40 cm / 8-15
in.
1298 - 007 - 16.09.2020
Note:
Settings > Lawn
distance will change along the boundary wire
everywhere in the work area.
3.10.8.1 To set the Drive Past Wire function
1.
2.
3.
4.
3.10.9 ECO mode
If
boundary loop, the guide wire and the charging station,
when the product is parked or is charging.
Note:
interference with other equipment, for example hearing
loops or garage doors.
Note:
push the STOP button before you remove the product
from the charging station. If not, the product can not be
started in the work area.
3.10.9.1 To set the ECO mode
1.
2.
Guide
3.
4.
3.10.10 To avoid collisions with the mower
house
If you have installed a mower house (available as
accessory), the wear on the product and the mower
Settings > Installation
house decreases when you select
collisions .
1.
2.
3.
Note:
in grass that is not cut around the charging station.
Drive Past Wire distance is changed, the
If the
To get access to the menu on
Do steps 1–3 in
page 23 .
Use the arrow button and the OK button to move
through the menu structure
> Drive Past Wire .
Use the arrow buttons to set the distance.
Push the BACK button.
ECO mode is activated, it switches off the signal in the
Use ECO mode to save energy and avoid
To start the product manually in the work area,
To get access to the menu on
Do steps 1–3 in
page 23 .
Use the arrow buttons and the OK button to move
through the menu structure
> ECO mode .
Push the OK button to select the
Push the BACK button.
To get access to the menu on
Do steps 1–3 in
page 23 .
Use the arrow buttons and the OK button to move
through the menu structure
> Mower house > Avoid house collisions .
Push the BACK button.
Avoid house collisions is selected it can result
If
Settings > Installation
Settings > Installation
ECO mode .
Avoid house
Settings > Installation
Installation - 27