To Charge The Battery; Adjust The Cutting Height - Gardena SILENO+ Operator's Manual

4.7.1 Example 1
This example is applicable to products with a
specified work area of 1600 m
is the same for the other models.
Schedule setting, Period 1: 00:00-24:00
Active period (A): 00:00-23:00
The schedule settings ensure that the product
begins cutting the lawn at 00:00. At 23:00 the
product has reached the maximum available
operating hours and is therefore parked in
standby mode. The product starts cutting the
grass again next day at 00:00.
Example: A specified work area of 1600 m
Operation, A = max. hours
Charging/Standby, B = min. hours

4.8 To charge the battery

WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
1378 - 003 - 16.04.2020
mode, the product automatically alternates
between mowing and charging.
2
, but the principle
1.
2.
3.

4.9 Adjust the cutting height

The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (6 cm / 2.4 in.).
4.9.1 To adjust the cutting height
1.
2.
2
23
1
3.
4.
Main area
Set the Main switch to position
Place the product in the charging station.
Slide the product in as far as possible to
ensure proper contact between the product
and the charging station. Refer to contact
Product overview on
and charging plates in
page 4
The display shows a message that charging
is in progress.
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
Push the STOP button to stop the product.
Open the hatch.
Turn the knob to the required position.
• Turn clockwise to increase the cutting
height.
• Turn counter-clockwise to decrease the
cutting height.
Close the hatch.
1 .
Operation - 33