Gardena SILENO city Operator's Manual page 39

Message Cause
Charging station
The contact between the charging plates on
blocked
the product and the contact plates on the
charging station is not good. The product has
made a number of tries to charge.
An object prevents the product to enter the
charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
Stuck in charging sta-
An object prevents the product to move out
tion
from the charging station.
Upside down
The product is in an incorrect position, the
product is tilting too much or is upside down.
Needs manual charg-
The product is set to the
ing erating mode.
Next start hh:mm The schedule setting prevents the product
from operating.
The product has operated the maximum cut-
ting time for the day.
The time or date in the product is not correct. Set the time or date. Refer to
Today's mowing
The product has operated the maximum cut-
completed
ting time for the day.
Lifted The lift sensor has been enabled because
the product has been lifted.
Wheel drive problem,
Grass or other object around the drive wheel. Clean the wheels and around the wheels.
right/left
Electronic problem Temporary electronic or firmware related
problem in the product.
Loop sensor prob-
lem, front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device
combination
Temporary battery
problem
Safety function faulty
Charging system
Incorrect type of battery.
problem
1298 - 007 - 16.09.2020
Action
Put the product in the charging station and
make sure that the charging plates and con-
tact plates are connected.
Remove the object.
Put the baseplate on level ground.
Install the guide wire correctly. Refer to
install the guide wire on page 20 .
Remove the object.
Put the product in the correct position.
Secondary area op-
Put the product in the charging station.
Change the schedule settings. Refer to
do the schedule settings on page 23 .
Usual operation of the product.
& date on page 28 .
Usual operation of the product. Refer to
Make an estimate of the necessary operating
time on page 23 .
Make sure that the product body can move
freely around its chassis. Remove or create
an island around objects that can cause the
chassis to be lifted. If the problem stays
speak to your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Use original batteries recommended by the
manufacturer.
To
To
To set the time
Troubleshooting - 39