Lan Command Reference; Lan Interface; Command Format; List Of Commands - Roland VC-100UHD Reference Manual

LAN Command Reference

Using the REMOTE connector to send specific commands to the unit from a controlling device lets you operate the unit remotely.

LAN Interface

This uses the REMOTE connector on the unit.
You use Telnet to operate the unit remotely over a LAN (TCP/IP protocol).
Communication standards
Port
LAN port (supports 100BASE-TX)
TCP port number 23
For methods of connecting to a network, refer to "Network Connections
and Settings" (p. 19).

List of Commands

Item
Select input channel for processing system set,0,9,0,[a][lf ]
Fade the main processing output to black
Fade the sub processing output to black
Fade the USB streaming output to black
Audio output level for USB streaming
Level of analog audio output
Retrieve SDI input status
Retrieve HDMI input status
Acquire version information
Transmitted command Response command
ack,0,9,0,[a][lf ]
set,0,32,0,[a][lf ] ack,0,32,0,[a][lf ]
set,0,52,0,[a][lf ] ack,0,52,0,[a][lf ]
set,0,57,0,[a][lf ] ack,0,57,0,[a][lf ]
set,0,217,0,[a][lf ] ack,0,217,0,[a][lf ]
set,0,232,0,[a][lf ] ack,0,232,0,[a][lf ]
ack,0,9,0[lf ]
get,0,9,0[lf ]
set,0,9,0,[a][lf ]
ack,0,16,0[lf ]
get,0,16,0[lf ]
set,0,16,0,[a][lf ]
ack,ver[lf ]
ver[lf ]
ver,VC-100UHD,[a][lf]

Command Format

Transmitted commands (control device0VC-100UHD)
Transmit specific commands from the control device to this unit.
Command Format
Obtains the model name and version information.
ver
ver lf
Sets a parameter.
set
set , Category ,
Obtains the current parameter value.
get , Category ,
get
When this unit correctly receives a command, it returns
set,[category],[ID],[sub-ID],[value][lf ].
* "lf" is the ASCII code "0aH, " and is a control code that indicates the
end of the command. H indicates a hexadecimal value.
ack response (VC-100UHD0control device)
When this unit correctly receives a command, it returns ack.
The ack response commands are described in "List of Commands. "
Error response (VC-100UHD0control device)
When this unit could not correctly receive a command, it returns an
error.
err , Transmitted command
* When sending a sequence of commands to the unit from a controller,
after each one, be sure to verify that an "ack" response is returned
before sending the next command.
Parameter
a: 0–7 Channel 1–8
a: 0 Cancel fade, 1 Execute fade
a: 0 Cancel fade, 1 Execute fade
a: 0 Cancel fade, 1 Execute fade
a: 0–127 Volume
a: 0–127 Volume
a: 0 Unsupported signal input, 1 Normal signal input,
2 No signal
a: 0 Unsupported signal input, 1 Normal signal input,
2 No signal
a: Version
* The version info is ASCII text strings.
ID , Sub-ID , Value lf
ID , Sub-ID lf
lf
33