Table of Contents
Advertisement
Setup Menu List
Output
SDI
Menu item
(Parameter)
Source Processing
3G-SDI Mapping
HDMI
Menu item
(Parameter)
Source Processing
Signal Type
Color Space
Audio Channel
Input Through
Analog Audio
Menu item
(Parameter)
Assign
Delay
Level
Equalizer
Hi Freq
Hi Gain
Mid Q
Mid Freq
Mid Gain
Low Freq
Low Gain
Mastering
Enhancer
Sense
Level
30
Value
(Bold: default)
Main, Sub
Level
A, Level B
Value
(Bold: default)
Main, Sub
HDMI, DVI-D
Auto, YUV422, YUV444, RGB Full,
RGB Limit
2CH, 5.1CH, 7.1CH
Disabled, Enabled
Value
(Bold: default)
Sets the output destination for the analog audio signal.
SDI OUT CH. 1/2–15/16
HDMI OUT CH. 1/2–7/8
USB OUT CH. 1/2–15/16
SDI IN CH. 1/2–15/16
HDMI 2 CH MIX
USB IN CH. 1/2
Analog IN CH. 1/2
Analog IN CH. 3/4
Test Tone
None
0.0–16.0fs (frames)
0–100–127
Disabled, Enabled
20–10k–20k
-12–0.0–+12
0.3–1.0–16
20–1.25k–20k
-12–0.0–+12
20–1.25k–20k
-12–0.0–+12
Disabled, Enabled
-24–0–-12dB
0–24
-24–0dB
Explanation
Sets the processing system output from the 12G-SDI OUT connector.
Sets the mapping of the 3G-SDI output.
Explanation
Sets the processing system output from the HDMI 4K OUT connector.
Sets the standard used for the output signal.
Sets the color space used during output.
Sets the maximum number of audio channels used during output.
When this is set to "Enabled, " signals input through the HDMI 4K IN connector
are output as-is from the HDMI 4K OUT connector.
* When "Input Through" is set to "Enabled, " set "Sub Processing" (p. 24) to
"Disabled. "
Explanation
Each channel of the 12G-SDI OUT connector
Each channel of the HDMI 4K OUT connector
STREAMING port
Each channel of the 12G-SDI IN connector
Two channels are output, down mixed with the audio from the HDMI 4K IN
connector.
STREAMING port
LINE IN jacks
AUDIO IN/OUT connector
Outputs a test tone.
Not assigned
Adjusts the audio delay time. Delays the output of the audio by the specified
time.
Adjusts the output level.
Enables/disables the equalizer.
Specifies the center frequency when changing the tone quality in the high band.
Boosts or attenuates the high band.
Adjusts the width of the frequency band when boosting or attenuating the
middle band.
Specifies the center frequency when changing the tone quality in the middle
band.
Boosts or attenuates the middle band.
Specifies the center frequency when changing the tone quality in the low band.
Boosts or attenuates the low band.
Enables/disables the mastering.
Adjusts the audio clarity.
Adjusts how much the mastering effects are applied.
Adjusts the volume of the mastered sound.
Advertisement
Table of Contents
