Table of Contents
Advertisement
2D Goniometer SmartLead User Manual
*Note: The 2D Goniometer is calibrated to a specific Ultium SmartLead. Therefore, the goniometer
must be continuously utilized with the SmartLead that it came with. It is recommended that the 2D
Goniometer SmartLead stays connected to the Goniometer at all times to avoid confusion. If the 2D
Goniometer SmartLead and its' paired goniometer get mixed up, contact Noraxon support
(https://www.noraxon.com/support-learn/support-request/) for information about recalibrating the
goniometer to a new sensor.
5.4 Device Communication (Driver) Software Installation
No driver installation is needed. The Ultium Receiver communicates over the USB port.
5.5 Companion Software Installation
The Footswitch SmartLead is compatible with several different software programs. Identify the
companion software that accompanied the equipment (MR3) and follow the appropriate instructions
given next.
5.5.1 MR3 Installation
1. Insert the MR3 feature map into the PC
2. A menu will automatically pop up
3. Click on "Install MR3" and follow the Wizard's instructions
4. Double click
5.6 Companion Software Configuration
Before the Footswitch can be used with the Noraxon Ultium system, the companion software must be
configured to recognize the different components that make up the system. Refer to the Ultium
system's hardware manual for instructions on the software module (MR3 myoMUSCLE) supplied with
the Noraxon system. For specific settings for the Footswitch SmartLead see below:
When assigned to a channel using the serial number, the software should automatically detect the
sensor as a Footswitch SmartLead:
5.6.1 MR3 Configuration
(Rev D January 2020)
on the icon to start the MR3 software.
Step 1
Enter the Hardware Setup
screen and setup the Noraxon
EMG system in accordance with
its provided hardware manual.
11
Advertisement
Table of Contents
