2D Goniometer SmartLead User Manual
It is recommended that you redetect sensors in the
hardware configuration every time the SmartLeads are
(Rev D January 2020)
Step 2
Click 'Detect Sensors in
Charger' (All sensors which you
would like to use must be in the
charger) – this will add the
SmartLead(s) to the list of
sensors (only if the unique
SmartLead is connected to their
corresponding sensor). If the
unique SmartLead (ex: 2D
Goniometer) is not connected to
the corresponding sensor during
detection, MR3 will assume you
are using the sensor to collect
EMG data. Click OK.
Step 3
Once back in the Home screen,
choose to create a new or edit
an existing configuration.
Step 4
In the measurement setup
screen, insert the Ultium system
into the Devices section in your
configuration.
12