Mounting The Terra Dc Wallbox - ABB Terra DC Wallbox Installation Manual

5.4.1

Mounting the Terra DC Wallbox

1. Carefully lower the Terra DC Wallbox onto its location.
2. Ensure cable(s) are not entrapped.
3. Place the wall frame in the correct position on the wall bearing by aligning the four holes of the charger
with the corresponding holes on the wall bearing.
4. Tighten the four screws with stainless steel 8.8 hexagonal bolts.
Mounting
holes
Mounting
holes
5. Place the unit on the wall frame by correctly aligning the 6 bolts (3 for each lateral side).
2 0 2 0- 0 8- 0 6
NOTICE
A minimum of two people are required to lift a Terra DC Wallbox during
installation. In general, local regulations should be followed as the
maximum weight to be lifted may vary.
TER R A DC WAL LB OX
2 4 / 41