Microcom 360C Operator's Manual page 78

Item
TIMEOUT NET
JAM RECOVERY
ERROR REPORT
HEX DUMP
PRINT ADJUST POSITION ADJUST
PAPER COLOR SET
SMR SETTING
Setting
0 SEC
5 SEC
~
90 SEC
~
290 SEC
295 SEC
300 SEC
ON
OFF
ON
OFF
EXECUTE
X ADJUST 0.00 MM
+0.25 MM
~
+2.00 MM
-2.00 MM
~
-0.25 MM
Y ADJUST 0.00 MM
+0.25 MM
~
+2.00 MM
-2.00 MM
~
-0.25 MM
0
+1
+2
-2
-1
YELLOW 0
+1
+2
+3
-3
-2
-1
MAGENTA 0
+1
+2
+3
-3
-2
-1
CYAN 0
+1
+2
+3
-3
-2
-1
77
Description
Sets the time that the network ports are left
open when an operation finishes.
Sets whether to print the page where a paper
jam occurred again.
When this is set to OFF, the remaining pages
are not printed, including the page where the
paper jam occurred.
Sets whether to print an error report when an
error occurs in the printer.
Prints a hex dump of the received data as a
QR code.
When the power of the printer is turned off, the
printer returns to the regular print mode.
Communication cannot be performed with the
status monitor, etc. while printing in the dump
format.
Corrects the position of the entire print image
in the direction perpendicular to the feed
direction of the paper. Set in increments of
0.25 mm.
Corrects the position of the entire print image
in the feed direction of the paper. Set in
increments of 0.25 mm.
Performs fine adjustment when faint white
dots or other visual problems occur in the print
results.
Lower the setting when there are faint white
dots occur and raise the setting when high
density areas become lighter.
Corrects uneven printing due to differences
in the print density/print frequency or
temperature/humidity. Change the yellow
setting when the image is uneven.
Corrects uneven printing due to differences
in the print density/print frequency or
temperature/humidity. Change the magenta
setting when the image is uneven.
Corrects uneven printing due to differences
in the print density/print frequency or
temperature/humidity. Change the cyan setting
when the image is uneven.