Chrysler Dodge Caravan 2002 Manual page 1248

RS
PISTON & CONNECTING ROD (Continued)
Fig. 69 Checking Connecting Rod Side Clearance
PISTON RINGS
STANDARD PROCEDURE
PISTON RING - FITTING
(1) Wipe cylinder bore clean. Insert ring and push
down with piston to ensure it is square in bore. The
ring gap measurement must be made with the ring
positioning at least 12 mm (0.50 inch) from bottom of
cylinder bore. Check gap with feeler gauge (Fig. 70).
Refer to Engine Specifications.
Fig. 70 Piston Ring Gap
1 - FEELER GAUGE
(2) Check piston ring to groove side clearance (Fig.
71). Refer to Engine Specifications.
PISTON RINGS - INSTALLATION
(1) Install rings with manufacturers I.D. mark fac-
ing up, to the top of the piston (Fig. 72).
Fig. 71 Piston Ring Side Clearance
1 - FEELER GAUGE
Fig. 72 Piston Ring Installation
1 - NO. 1 PISTON RING
2 - NO. 2 PISTON RING
3 - SIDE RAIL
4 - OIL RING
5 - SPACER EXPANDER
CAUTION: Install piston rings in the following
order:
• Oil ring expander.
• Upper oil ring side rail.
• Lower oil ring side rail.
• No. 2 Intermediate piston ring.
• No. 1 Upper piston ring.
(2) Install the side rail by placing one end
between the piston ring groove and the expander.
Hold end firmly and press down the portion to be
installed until side rail is in position. Do not use a
piston ring expander (Fig. 73).
ENGINE 2.4L 9 - 47