Installation Process; Figure 2-1 Installation Process Flowchart - American Dynamics IP SpeedDome Ultra 8 Configuration And User's Manual

Installation

Installation process

Ensure the required power, network and alarm cables are
installed and the network cable is labelled and disconnected at
the network patch panel or access point.
Remove the IPSDU8, dome camera and corresponding mount from
their packaging.
Referring to the IPSDU8 Installation Guide (8200-0885-01) install
the following:
Connect a laptop to the
IPSDU8 Ethernet cable
located at the patch
panel or access point.
Open a browser window and enter the IP address of the IPSDU8,
192.168.1.80.
Refer to Web Configuration (Chapter 3) and configure the following
settings on the IPSDU8:
Within the browser window navigate to the Live video page and follow
the Web Configuration chapter to access the SDU8 dome configuration
menu, then using the SDU8 User Manuals, configure the required
dome settings.
If a laptop was used to configure the IPSDU8, disconnect the laptop
and connect the IPSDU8 Ethernet cable into the network patch panel
or access point.
Refer to the Intellex/VideoEdge™ NVR Setup Guide and follow the
procedure for adding a IPSDU8.
2-2
• Mount (which has PCB and cables installed)
• SDU8
• Bubble
Is the IPSDU8 on the
same subnet address
NO
as the Intellex or
VideoEdge™ NVR?
• TCP/IP settings
• Video Input (if applicable)
• Event Inputs (if applicable)

Figure 2-1 Installation process flowchart

YES
Connect the IPSDU8
Ethernet cable into
the network patch
panel or access point.
Configuration and User Guide