Disassembling The Camera; Connecting The Wires - American Dynamics Illustra Flex Series Quick Start Manual

2.2.2 Disassembling the Camera

Please refer to the figure 2-1 for pictorial index. Gently press the button to take off camera off camera housing
(4). Remove the inner liner (3) by gently pulling it free of the two notches (2) in the housing. Set the camera a
housing (5) and inner liner (3) aside.

2.2.3 Connecting the wires

This unit supports one of the following options as power supply.

DC 12V: Connect 12V (－) to terminal =DC 12V－, and Connect 12V (＋) to terminal =DC 12V＋

AC 24V: Connect 24V (～) cables to terminals ～AC 24V

PoE: Connect the RJ-45 jack to a PoE compatible network device that supplied power through the
Ethernet cable.
Insert Audio cable and alarm cable to the unit, and connect the network cable to the RJ-45 terminal of a
switch.
Caution If using DC supply, make sure the polarity is correct. Incorrect connection may cause
malfunction and/or damage to the unit.
F 2-1: D
IGURE ISASSEMBLING
11
Illustra Flex 1MP & 3MP Indoor Dome
T C
HE AMERA