Led Status Descriptions - American Dynamics IP SpeedDome Ultra 8 Configuration And User's Manual

Technical Specifications

LED Status Descriptions

Power LED
• On with repeating slow short flashes off – normal operation
• Rapidly flashing – invalid stored configuration/operating on factory defaults.
Client LED
• On – operating normally with one client connected
• Off – operating normally with no clients connected
• Flashing rapidly – network not ready, no IP address assigned.
Video/Alarm LED
• Not used at this release, indicates alarm conditions.
Note
Power and Video/Alarm LEDs rapidly flashing together indicates a firmware or configuration
update is in progress.
Note
During the power up process all three LEDs may flash on or off, however if all three LEDs are
flashing together followed by a short delay and the flash sequence repeated, this indicates a
Power On Self Test (POST) error. The number of rapid flashes indicates the actual error code.
Contact Technical Support in this instance.
5-2 Configuration and User Guide