Using The Select Antenna Gain Setting; Using The Data Packet Encryption Setting - Cisco FM1200 Installation And Configuration Manual

1. Click the
2. Choose the correct transmission power level from the following
list of options:
• Transmission power can be manually adjusted from -3
dBm to 24 dBm.
• If you select the AUTO option, the unit will automatically
choose the most efficient transmission power level
according to prevailing conditions. However, the unit will
not exceed the last manually selected Max TX Power
parameter.
3. Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.

Using the Select Antenna Gain setting

This setting controls the maximum antenna gain in dBm. By default,
antenna gain is not pre-set at the factory.
To use the Select Antenna Gain setting, do the following steps:
1. Click the
2. Choose the correct antenna gain level. Gain can be manually
adjusted from 0 dBm to 36 dBm.
3. Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.

Using the Data Packet Encryption setting

This setting controls whether Advanced Encryption Standard (AES)
encryption is applied to outgoing data packets.
IMPORTANT
The Data Packet Encryption setting must be the same on all
Cisco units that are part of the same network.
In Cisco devices, AES is applied using a proprietary encoding
algorithm, enabling industry-grade network security.
IMPORTANT
The AES feature must be enabled using a software plug-in
(FM-AES). Contact your Cisco Networks representative for
details.
To use the Data Packet Encryption setting, do the following steps:
1. Click the Data Packet Encryption drop-down menu.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Select TX Max Power: drop-down menu.
Select Antenna Gain: drop-down menu.
Page 95 of 175