Descale - Dualit Cafe PLUS Instruction Manual & Guarantee

DESCALE

HARD WATER WILL CAUSE LIMESCALE BUILD-UP, RESULTING
IN BLOCKAGES THAT CAUSE PERMANENT DAMAGE.
IMPORTANT NOTICE: PRODUCT FAILURE DUE TO THE
BUILD-UP OF LIMESCALE IS NOT COVERED BY GUARANTEE.
Dualit recommends cleaning and descaling regularly, in a well-ventilated area to prevent
limescale build up in the machine. Please note: Always clean your machine before
beginning the descaling process. Refer to page 16 for the cleaning section. See
Limescale warning on page 6 for frequency in your area in accordance with the hardness of your
water. It is essential that a compatible descaler is used - visit www.dualit.com/machine-care for
descaler options. The descale process takes approximately 30 minutes.
Caution: Avoid contact with descaling solution. Steam released during descale
process may be harmful. Risk of scalding and injury.
1 THE DESCALER 2
KILROCK KILROCK KILROCK
KILROCK KILROCK
MULTI-PURPOSE MULTI-PURPOSE MULTI-PURPOSE
MULTI-PURPOSE MULTI-PURPOSE
DESCALER DESCALER DESCALER
DESCALER DESCALER
Ensure your descaling The Coffee & Tea Buttons
will quickly flash, immediately
product is suitable for
coffee machines; follow after switching on, to indicate
descaling product descaling is required. Ensure
instructions carefully. your descaling product is
If you are using a water suitable for coffee machines
and follow descaling product
softener, ensure water
instructions carefully.
softener is removed before
adding descaler. Fill water
tank with descale solution.
DESCALING FILL TANK
3
REQUIRED
Ensure the correct ratio of
water is used to create the
Descaling Solution. Turn the
machine off, remove the
Water Tank and fill with the
Descaling Solution. Remove
Drip Tray and place large
container under the nozzle.
14
3 PRESS & HOLD 4
Insert Water Tank. Turn on Ensure the Lever is pushed
and wait for the Coffee & Tea down fully and no capsule is
Buttons to stop flashing. Press present, then press the Coffee
both Coffee & Tea Buttons Button to start descaling. Your
firmly at the same time and machine will dispense. This will
hold for 5 seconds. Both continue until the Water Tank
Buttons will now quickly flash. is empty. Wait 10 minutes for
the Descaling Solution to take
effect.
6 EXIT
To exit the Descale Mode, press both Coffee & Tea Buttons
at the same time and hold for 5 seconds. Both lights will go
back to solid illumination. NOTE: if the machine is turned off in
Descale Mode, it will stay in this mode when switched back on.
If you are using water softener, ensure that it is placed back into
the Water Tank once the Water Tank is clean.
DISPENSE 5 RINSE TANK
AND FLUSH
Rinse the Water Tank and
fill with fresh water. Repeat
step 4 (Dispense) and flush
at least two full tanks
of water through the
machine to remove any
traces of the Descaling
Solution.
15