Factory Reset; Descale Mode - Dualit Cafe Cino Instruction Manual & Guarantee

FACTORY RESET

Carrying out the following steps will reset the machine's dosing volumes.
For other issues, please refer to Troubleshooting on page 23.
1 SWITCH OFF 2
Ensure the machine is Press and hold both the
switched off using the Cappuccino and Latte
Power Switch but plugged Buttons.
in at the mains.
4 RESTART 5
MACHINE
Turn the Power Switch off The machine's dispense volume is now reset to factory
and unplug at the mains. setting. The factory setting of the machine is programmed to
Your machine is now reset 35ml for the Espresso Button, 70ml for the Lungo Button and
to the factory setting. 180ml for the Tea Button.
HOLD BOTH 3 SWITCH ON
BUTTONS MACHINE
With both Buttons held
down, turn the machine
on using the Power Switch.
Keep holding the Buttons for
5 seconds. The Cappuccino
and Latte Buttons will
illuminate.
COMPLETE
18

DESCALE MODE

Dualit recommends descaling regularly to prevent limescale build up in the
machine. Your machine has a Descale Counter which will indicate when to
descale. IMPORTANT NOTICE: Product failure due to the build
up of limescale is not covered by guarantee - descale regularly.
THE DESCALER
1 2
Buttons will flash clockwise Ensure the correct ratio of
to indicate that descaling is water is added to create the
required when your machine descaling solution. Remove
is switched on. Ensure your the Water Tank and fill with
descaling product is suitable the Descaling Solution. Remove
for coffee machines and Drip Tray and place large
follow descaling product container under the nozzle.
instructions carefully.
4 DESCALE NOZZLE 5
To descale the Nozzle, press To descale the Steam Wand, press the Cappuccino or Latte
the Coffee or Tea Button to Button to start descaling. Your machine will dispense. Once
start descaling. Your machine 0.2L of Descaling Solution has been dispensed through the
will dispense. Once 0.5L of nozzle, the dispense will automatically stop.
Descaling Solution has been
dispensed through the nozzle, the
dispense will automatically stop.
FILL TANK PRESS & HOLD
3
Insert Water Tank. Turn
on and wait for all Buttons
to illuminate. Press both
Coffee & Tea Buttons at the
same time and hold for 5
seconds. Buttons will flash
alternately.
DESCALE STEAM
WAND
Wait 10 minutes
for descaling to
take effect.