Table of Contents
Advertisement
COFFEE & TEA EXTRACTION
When switching from coffee to tea, all dosing buttons may flash due to the Thermobloc
heating water to your chosen temperature. When switching from tea to coffee, the machine
may purge to cool the Thermobloc. This is normal operation. PLEASE CAREFULLY
SELECT REQUIRED BUTTON. FAILURE TO DO SO MAY BLOCK YOUR
SHOWERHEAD, PREVENTING OR SLOWING DOWN EXTRACTION.
CAUTION: DO NOT USE TEA BUTTON WITH COFFEE CAPSULES, THIS
MAY DAMAGE YOUR MACHINE AND INVALIDATE YOUR WARRANTY.
1
ATTACH HOLDER
2
SELECT AUTO
DOSE
LOCK
Align the Filter Holder with the
To extract, press the espresso
open lock symbol, insert then
or double espresso Auto
rotate 60° past the closed lock
Dosing button. To extract tea,
symbol. Ensure the Holder
press the tea Auto Dosing
is fully locked before
button. Caution: Never use
dispensing. Risk of
Auto Dose Tea function
scalding. Place 1 or 2 warmed
with coffee capsules.
cups directly under the Nozzles
of the Filter Holder.
4
5
STOP
MANUALLY STOP
EXTRACTION
EXTRACTION
When the correct dose has
Stop extraction mid cycle by
dispensed, the machine will
pressing illuminated Dose
automatically stop. Allow to
Button, when pressed again
cool for 10 seconds before
full dose cycle will resume.
removing NX Holder. All
Auto Dosing buttons will illuminate
when ready for the next extraction.
Unplug when not in use.
3
EXTRACTION
If the machine stops mid
extraction, discard and
replace the capsule, ESE pod
or ground coffee and restart
by pressing the required
Dosing Button.
6
BETWEEN DRINKS
Dispense a cup full of
water through the machine
between making a coffee
and tea to prevent tainting.
16
WHEN SWITCHING FROM STEAM TO COFFEE OR
TEA EXTRACTION: WAIT 10 SECONDS BEFORE
REMOVING THE HOLDER AFTER DOSING FIRST DRINK
IS COMPLETE.
7
8
CLEAN FILTER OR
TURN OFF
NX
ADAPTOR
®
When using the Filter Holder,
Turn machine off by pressing
knock out the grounds over a
Power ON/OFF Switch after
bin. Rinse the Filter under
you have rinsed through and
running water to remove any
finished using the machine.
coffee grounds. Use the Filter
This will save energy.
Pin to unblock the filters or
Unplug when not in use.
NX
Adaptor if required.
®
FROTHING MILK
IMPORTANT NOTICE: AFTER EACH USE, WIPE THE STEAM WAND &
FLUSH THE INSIDE OF THE WAND BY DISPENSING WATER THROUGH
THE WAND.
CAUTION! Take care when using the Milk Jug, as edges may be sharp.
1
SELECT STEAM
2
ATTACH NOZZLE
Press the Steam Button. It will
Put the Froth Nozzle on the
flash red until the temperature
end of the Steam Wand.
is correct for steam, then it will
Push up against the Stopper
turn solid red.
shown above. Caution:
Wand may be hot. Risk
of scalding.
3
POSITION JUG
Use 75-200ml of cold
semi-skimmed milk in a
stainless steel jug. Position
the head of the Froth Nozzle
just under the surface of the
milk. Risk of scalding.
17
Advertisement
Table of Contents
