Mounting Options; Standard Wall Mounting Total Access 900 Series (Brackets Included With All Units) - ADTRAN Total Access 900 Series Hardware Installation Manual

TA 900 Series (3rd Gen) HIG

Mounting Options

The Total Access 900 Series may be installed in a wallmount or rackmount configuration. The
following sections provide step-by-step instructions for wall mounting and rack mounting.

Standard Wall Mounting Total Access 900 Series (Brackets Included with all Units)

Follow these steps to safely wallmount the Total Access 900 Series
• To avoid damaging the unit, use only the screws included in the shipment when
attaching mounting ears to the chassis.
• When wall mounting the Total Access 900, care must be taken not to damage
the power cord. Do not attach the power cord to the building surface or run it
through walls, ceilings. floors, or openings in the building structure.
• The receptacle outlet must be installed near the equipment and must be easily
accessible.
Instructions for Wall Mounting Total Access 900 Series
Step
1 Attach the wall mounting brackets (using the included screws) so that the wall mount flange
protrudes from the bottom of the unit (see
2 Decide on a location for the Total Access 900 Series. Keep in mind that the unit needs to be
mounted at or below eye level so that the LEDs are visible.
Warning! The Total Access 900 Series can only be wall mounted with the front panel facing to
the right, to the left, or downward (see the example in
with the LED facing up.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two #6 to #10 (length not to exceed
board thickness) wood screws through the unit's brackets and into the mounted board (see
Figure 3 on page
5 Proceed to the steps given in
61213908F1-34A
20).
Grounding Instructions on page
Copyright © 2020 ADTRAN, Inc.
:
Action
Figure 3 on page 20)
Figure 3 on page
22.
Unit Installation
20). Do not mount
19