Mounting Options; Figure 6. Wall Mounting The Unit - ADTRAN Total Access 908e Hardware Installation Manual

Unit Installation

Mounting Options

The Total Access 900e Series may be installed in a wallmount, rackmount, or tabletop configuration.
The following sections provide step-by-step instructions for rack mounting and wall mounting.
Wall Mounting Total Access 900e Series
Instructions for Wall Mounting Total Access 900e Series
Step
1 Attach the wallmount brackets to the unit using the supplied screws.
2 Decide on a location for the Total Access 900e Series. Keep in mind that the unit needs to be
mounted at or below eye level so that the LEDs are visible.
Warning! Do not mount the chassis with the LEDs facing up (see Figure 6).
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud. Important! Mounting to a stud ensures stability. Using sheetrock anchors may
not provide sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two 3/32-inch up to 1/8-inch
(1 1/ 2-inch or greater length) wood screws through the unit's brackets and into the mounted
board.
5 Proceed Grounding Instructions on page 29.
Step 1: Prepare the
mounting surface by
attaching a board
(typically plywood, 3/4"
to 1" thick) to the wall.
(The board must be
attached to a stud in
the wall for stability.)
22
Total Access 900e Series Hardware Installation Guide
Action
LEDs Pointing Down
Step 2: Wallmount the
Total Access 900e Series
unit using two 3/32" to
1/8" (1 1/2" or greater in
length) wood screws.

Figure 6. Wall Mounting the Unit

Copyright © 2006 ADTRAN, Inc.
LEDs Pointing Sideways
64240916L1-34D