Table of Contents
Advertisement
Free motion darning, embroidery and
monogramming
3.5
Preparation for embroidering and
monogramming
* Embroider hoop is not included with
the machine.
Change the presser foot to the button
sewing foot.
Install the darning plate.
Remove the presser foot and the
presser foot holder.
Draw the desired lettering or design
on the surface of the fabric.
Stretch the fabric between the
embroidery hoop as firmly as possible.
Place the fabric under the needle.
Make sure the presser foot bar is
down to its lowest position.
Turn the handwheel towards you to
bring up the bobbin thread through the
fabric. Sew a few securing stitches at
the starting point.
Hold the hoop with thumb and
forefinger of both hands while pressing
the material with the middle and third
finger and supporting the outside of
the hoop with your small finger.
Attention:
Keep fingers away from moving parts,
especially needles.
Note:
When you finish the work, move the
darning plate.
41
Advertisement
Table of Contents
