Table of Contents
Advertisement
4. Draw the thread from the spool and
place the thread in between the
upper thread guide.
5. Guide the thread ahead and pull
the thread through the pre-tension
spring as illustrated.
6. Continue to guild the thread down
to the silver discs to keep the
thread in proper tension.
7. Pass the thread under the take-
up spring then pull it upwards as
arrow marks illustrated.
8. Pull the thread to the top then pass
the thread through the slotted eye
of the take-up lever. Guide the
thread down afterwards.
9. Now pass the thread behind the
thin wire needle clamp guide.
Pull the end of the thread through
the needle from front to rear and
pull out about 10 cm of thread. Use
the needle threader to thread the
needle.
16
Advertisement
Table of Contents
