Connecting The Ground And Antenna Cables; Figure 2-3: Bottom Panel Of The Outdoor Unit (Without The Seal Assembly) - Alvarion BreezeNET B System Manual

2.3.2

Connecting the Ground and Antenna Cables

The Ground terminal (marked ╤) is located on the bottom panel of the outdoor
unit. The Antenna RF connector (marked
model ODU.
To prepare the ground cable:
Connect one end of a grounding cable to the ground terminal and tighten the
1
ground screw firmly.
Connect the other end of the ground cable to a ground connection.
2
To connect the RF cable (D model):
Connect one end of the coaxial RF cable to the RF connector on the top panel
1
of the unit
Connect the other end of the RF cable to the antenna.
2
The RF connectors should be sealed properly to protect against rain and
3
moisture

Figure 2-3: Bottom Panel of the Outdoor Unit (without the seal assembly)

NOTE
The MAC Address of the unit is marked on both the ODU and the IDU (on the bottom side of the
unit). If due to any reason the ODU is not used with the IDU with whom it was shipped, the MAC
Address of the system is in accordance with the marking on the ODU.
Installation
Installing the Outdoor Unit
) is located on the top panel of the D-
19