Alvarion BreezeNET B System Manual page 83

Point-to-point wireless bridge release 3.1
Hide thumbs Also See for BreezeNET B:
Table of Contents

Advertisement

Total received concatenated frames: The total number of concatenated
frames received from the wireless media, including duplicate frames. There
are also separate counts for concatenated frames that include one frame
(Single), two frames (Double) or more than two frames (More). For more details
refer to section
Bad fragments received: The number of fragments received from the wireless
media containing CRC errors.
Duplicate frames discarded: The number of data frames discarded because
multiple copies were received. If an acknowledgement message is not received
by the originating unit, the same data frame can be received more than once.
Although duplicate frames are included in all counters that include data
frames, only the first copy is forwarded to the Ethernet port.
Internally discarded MIR: The number of data frames received from the
Ethernet port that were discarded by the MIR mechanism to avoid exceeding
the maximum permitted information rate.
4.2.5.2
Ping Test
The Ping Test submenu is used to control pinging from the unit and includes the
following options:
Destination IP Address: The destination IP address of the device being
pinged. The default IP address is 192.0.0.1.
Number of Pings to Send: The number of ping attempts per session. The
available range is from 0 to 9999. The default value is 1. Select 0 for
continuous pinging.
Ping Frame Length: The ping packet size. The available range is from 60 to
1472 bytes. The default value is 64 bytes.
Ping Frame Timeout: The ping frame timeout, which is the amount of time
(in ms) between ping attempts. The available range is from 100 to 60,000 ms.
The default value is 200 ms.
Start Sending: Starts the transmission of ping frames.
Stop Sending: Stops the transmission of ping frames. The test is
automatically ended once the number of pings has reached the value specified
in the No. of Pings parameter, described above. The Stop Sending option can
be used to end the test before completing the specified number of pings, or if
continuous pinging is selected.
Operation and Administration
.
4.2.6.5.7
Menus and Parameters
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents