Alvarion BreezeNET B System Manual page 139

NOTE
The Shared Key option cannot be selected before at least one Key is defined. In the RB, a Default
Key that refers to a valid Key must be selected.
The BU and the RB it serves should be configured to the same Authentication Algorithm option.
4.2.6.7.2 Data Encryption Option
The Data Encryption Option allows enabling or disabling data encryption. When
enabled, all data frames, including frames using management protocols such as
Telnet, FTP, TFTP, SNMP, DHCP and ICMP, are encrypted.
The default is Disable.
NOTE
The BU and the RB it serves should be configured to the same Data Encryption Option.
An RB with Data Encryption Option enabled can accept non-encrypted data frames
4.2.6.7.3 Security Mode
The Security Mode option enables selecting the algorithm to be used for
encrypting the authentication messages and/or data frames.
The available options are WEP and AES.
The default is WEP.
NOTE
The BU and the RB it serves should be configured to the same Security Mode option.
4.2.6.7.4 Default Key (RB only)
The Default Key defines the Key to be used for encrypting/decrypting the
authentication messages (Shared Key mode) and/or data frames (Data
Encryption enabled). The BU learns the Default Key from the RB.
Available values range from 1 to 4.
The default is KEY # 1.
4.2.6.7.5 Default Multicast Key (BU only)
The Multicast Default Key defines the Key to be used for encrypting/decrypting
multicasts and broadcasts when Data Encryption is enabled.
Available values range from 1 to 4.
The default is KEY # 1.
Operation and Administration
Menus and Parameters
121