Working With The Monitor Program; Accessing The Monitor Program Using Telnet; Table 4-1: Default Passwords - Alvarion BreezeNET B System Manual

Chapter 4 - Operations
4.1

Working with the Monitor Program

4.1.1

Accessing the Monitor Program Using Telnet

Connect a PC to the Ethernet port, using a crossed cable.
1
Configure the PC's IP parameters to enable connectivity with the unit. The
2
default IP address is 10.0.0.1.
Run the Telnet program. The Select Access Level menu is displayed.
3
Select the required access level, depending on your specific access rights. A
4
password entry request is displayed. Table 4-1 lists the default passwords for
each of the access levels.
Access Rights
Read-Only
Installer
Administrator
NOTE
Following three unsuccessful login attempts (using incorrect passwords), the monitor program is
blocked for several minutes. To enable access to the monitor program during that time, the unit
must be reset via SNMP or by disconnecting/reconnecting power.
Enter your password and press Enter. The Main Menu is displayed as shown
5
in Figure 4-1. The unit type, SW version number and SW release date
displayed in the Main Menu vary according to the selected unit and SW
version.
38

Table 4-1: Default Passwords

Password
public
user
private
BreezeNET B System Manual